How To Fix UMG267 - The valid range for the checkpoint frequency is 1000 to 2147483647).

SAP Error Message - Details

• Message type: E = Error

• Message class: UMG - Message Class for the Unicode Migration Tool.

• Message number: 267

• Message text: The valid range for the checkpoint frequency is 1000 to 2147483647).

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message UMG267 - The valid range for the checkpoint frequency is 1000 to 2147483647). ?

  The SAP error message UMG267 indicates that the checkpoint frequency value you have set is outside the valid range. The valid range for the checkpoint frequency in SAP is between 1000 and 2147483647. This error typically occurs when configuring the database or system parameters related to the checkpoint frequency.
  Cause:
  The error is caused by setting a checkpoint frequency value that is either:
  
  Below the minimum threshold of 1000.
  Above the maximum threshold of 2147483647.
  
  Solution:
  To resolve this error, you need to adjust the checkpoint frequency value to fall within the valid range. Here are the steps to do this:
  
  
  Access the Configuration:
  
  Log in to your SAP system.
  Navigate to the relevant configuration area where the checkpoint frequency is set. This could be in the database configuration or system parameters.
  
  
  
  Modify the Checkpoint Frequency:
  
  Locate the parameter for checkpoint frequency.
  Change the value to a number between 1000 and 2147483647. For example, you might set it to 1000 if you want the minimum frequency or a higher value based on your system's requirements.
  
  
  
  Save Changes:
  
  After adjusting the value, save the changes.
  
  
  
  Restart the System (if necessary):
  
  Depending on the changes made, you may need to restart the SAP system or the database for the changes to take effect.
  
  
  
  Related Information:
  
  Checkpoint Frequency: This parameter controls how often the database writes data from memory to disk. A lower frequency can lead to more frequent writes, which may impact performance, while a higher frequency can improve performance but may risk data loss in case of a failure.
  Performance Tuning: When setting the checkpoint frequency, consider the performance characteristics of your system and the workload it handles. It may be beneficial to consult with a database administrator or SAP Basis consultant for optimal settings.
  Documentation: Always refer to the official SAP documentation or notes for the specific version of your SAP system for any additional guidelines or recommendations regarding configuration parameters.
  
  By ensuring that the checkpoint frequency is set within the valid range, you should be able to resolve the UMG267 error and maintain optimal system performance.