How To Fix UGMD7009 - Target system &1 cannot be used

SAP Error Message - Details

• Message type: E = Error

• Message class: UGMD7 - Messages for Package UGMD7

• Message number: 009

• Message text: Target system &1 cannot be used

What causes this issue?

An attempt was made using RFC destination &V1& to access an R/3 System
with a release earlier than 4.5B.

System Response

It is not possible to access R/3 Systems with a release earlier than
4.5B.

How to fix this error?

Change the RFC destination.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UGMD7009 - Target system &1 cannot be used ?

  The SAP error message UGMD7009 indicates that the target system specified cannot be used for the operation you are trying to perform. This error typically arises in the context of system landscape management, especially when dealing with system copies, transports, or system migrations.
  Causes:
  
  System Status: The target system may be in a status that does not allow it to be used (e.g., it might be in maintenance mode, not properly configured, or not started).
  Connection Issues: There may be network connectivity issues between the source and target systems.
  Authorization Issues: The user executing the operation may not have the necessary authorizations to access the target system.
  Configuration Errors: The target system may not be correctly configured in the SAP landscape (e.g., incorrect RFC destination settings).
  System Type: The target system may not be of the correct type for the operation being performed (e.g., trying to transport to a non-productive system).
  
  Solutions:
  
  Check System Status: Ensure that the target system is up and running and is not in maintenance mode. You can check this in the SAP GUI or through the system's administration tools.
  Verify Connections: Test the connection to the target system using transaction SM59 (RFC Destinations). Ensure that the connection is working and that there are no network issues.
  Review Authorizations: Make sure that the user has the necessary authorizations to perform the operation on the target system. You may need to consult with your security team to verify this.
  Check Configuration: Review the configuration settings for the target system in the SAP landscape. Ensure that the RFC destination is correctly set up and points to the right system.
  System Type Validation: Confirm that the target system is of the correct type for the operation you are trying to perform. For example, if you are trying to transport changes, ensure that the target system is a valid transport target.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as SM59 (RFC Destinations), ST22 (Dump Analysis), and SM21 (System Log) for troubleshooting.
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that may address this specific error message or provide additional troubleshooting steps.
  Documentation: Review SAP documentation related to system landscape management and transport management for best practices and configuration guidelines.
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.