How To Fix UCF3003 - Key figure &1 cannot be simultaneously checked and rounded

UCF3003 - Overview

• Message type: E = Error

• Message class: UCF3 - Messages for Rounding

• Message number: 003

• Message text: Key figure &1 cannot be simultaneously checked and rounded

What causes this issue?

According to the current settings, key figure "&V1&" is to be checked
as well as rounded. This is not feasible.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Decide whether to check or to round the key figure, and change the
settings accordingly.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UCF3003 - Key figure &1 cannot be simultaneously checked and rounded ?

  The SAP error message UCF3003 indicates that there is a conflict in the configuration of a key figure in the context of the SAP system, particularly in the area of planning and data processing. This error arises when a key figure is set to be both checked and rounded simultaneously, which is not allowed.
  
  Cause:
  The error occurs due to the following reasons:
  
  Configuration Conflict: The key figure in question has been configured to perform both checking (validating the data against certain criteria) and rounding (adjusting the numerical value to a specified precision) at the same time.
  Incompatibility: The system does not support the simultaneous execution of these two operations for the same key figure, leading to this error message.
  
  
  Solution:
  To resolve the UCF3003 error, you can take the following steps:
  
  
  Review Key Figure Settings:
  
  Go to the configuration settings for the key figure that is causing the error.
  Check the properties of the key figure to see