How To Fix U9140 - Material &1 plant &2 prod.vers. &3: Component &4 is an intra material

SAP Error Message - Details

• Message type: E = Error

• Message class: U9 - Message Class for Output in Application Log

• Message number: 140

• Message text: Material &1 plant &2 prod.vers. &3: Component &4 is an intra material

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message U9140 - Material &1 plant &2 prod.vers. &3: Component &4 is an intra material ?

  The SAP error message U9140 indicates that there is an issue related to a component in a production version of a material. Specifically, the message states that the component is classified as an "intra material," which typically means that the component is not set up correctly in the system for the production version being used.
  Cause:
  
  Intra Material Definition: The component specified in the error message is defined as an intra material, which means it is not intended to be used in the context of the production version or plant specified.
  Configuration Issues: There may be configuration issues in the Bill of Materials (BOM) or the production version setup that do not allow the component to be used in the specified context.
  Master Data Issues: The material master data for the component may not be correctly maintained, leading to inconsistencies in how it is recognized in the system.
  
  Solution:
  
  Check Material Master Data: Verify the material master data for the component (material &4). Ensure that it is correctly set up and that it is not marked as an intra material if it should be used in the production version.
  Review Production Version: Check the production version (&3) for the material (&1) in the specified plant (&2). Ensure that the component is included in the BOM for that production version.
  BOM Configuration: Review the BOM configuration to ensure that the component is correctly assigned and that there are no inconsistencies.
  Consult Documentation: Refer to SAP documentation or help resources for further details on intra materials and how they should be configured.
  Contact SAP Support: If the issue persists after checking the above points, consider reaching out to SAP support for assistance, as they can provide more specific guidance based on your system configuration.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CS03 (Display BOM), CS02 (Change BOM), or C223 (Maintain Production Versions) to investigate and resolve the issue.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Roles: Ensure that you have the necessary authorizations to view and modify the material master and BOM data.
  
  By following these steps, you should be able to identify and resolve the issue causing the U9140 error message in SAP.