How To Fix TT008 - Invalid test case name: "&"

SAP Error Message - Details

• Message type: E = Error

• Message class: TT - Extended Computer Aided Test Tool (eCATT) messages

• Message number: 008

• Message text: Invalid test case name: "&"

What causes this issue?

The specified procedure number is not in the name space.
SAP name space SSSYXXXX
Customer name space ZSSSYXXX
Z fixed value for customer name space
SSS three-character Id of the system on which the procedure was
created
Y serial number from 0 - Z
X serial number from 0 - 9

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message TT008 - Invalid test case name: "&" ?

  The SAP error message TT008, which states "Invalid test case name: '&'", typically occurs in the context of SAP's testing tools, such as SAP Solution Manager or when using the Test Management functionalities. This error indicates that the test case name provided is invalid, often due to the presence of special characters or formatting issues.
  Cause:
  
  Invalid Characters: The test case name may contain special characters (like "&", "!", "@", etc.) that are not allowed.
  Empty or Null Name: The test case name might be empty or not properly defined.
  Length Restrictions: The name may exceed the maximum character limit set by the system.
  Incorrect Formatting: The name might not adhere to the expected naming conventions or formats.
  
  Solution:
  
  Check for Special Characters: Ensure that the test case name does not contain any special characters that are not permitted. Replace or remove any invalid characters.
  Use Valid Naming Conventions: Follow the naming conventions recommended by SAP. Typically, this means using alphanumeric characters and avoiding spaces or special symbols.
  Ensure Non-Empty Name: Make sure that the test case name is not empty and is properly defined.
  Check Length: Verify that the name does not exceed the maximum length allowed by the system.
  Recreate the Test Case: If the issue persists, try creating a new test case with a different name that adheres to the guidelines.
  
  Related Information:
  
  SAP Documentation: Refer to the official SAP documentation for guidelines on naming conventions and restrictions for test cases.
  SAP Community: Engage with the SAP Community forums for insights and solutions from other users who may have encountered similar issues.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  
  If the problem continues after following these steps, consider reaching out to your SAP support team for further assistance.