How To Fix TR_AUSL241 - Successor &1 cannot be used: component is &2 instead of &3

TR_AUSL241 - Overview

• Message type: E = Error

• Message class: TR_AUSL - Software Delivery Composer Messages

• Message number: 241

• Message text: Successor &1 cannot be used: component is &2 instead of &3

What causes this issue?

A delivery request can only be used as a <DS:DE.DLV_FOLWTK>successor
</> for a delivery request that is to be registered if both are
assigned to the same software component (in the same version).
The delivery request &V1& selected as successor is assigned to the
software component &V2& however, while the delivery request &V4& being
registered is assigned to software component &V3&.

System Response

The action was terminated. You are given the option of correcting your
entry.

How to fix this error?

Check the successor request you entered and correct.

Error message extract from SAP system. Copyright SAP SE.

TR_AUSL241 - Details

• The SAP error message TR_AUSL241 indicates that there is a mismatch in the component type of a successor in a task or project. Specifically, the message states that the successor cannot be used because the component is of a different type than expected. Here’s a breakdown of the components of the error message:
  
  Successor &1: This refers to the specific task or project that is being referenced as a successor.
  Component is &2: This indicates the actual component type of the successor.
  Instead of &3: This indicates the expected component type that the system is looking for.
  
  Cause
  The error typically arises due to one of the following reasons:
  
  Incorrect Configuration: The successor task or project may have been incorrectly configured or assigned a component type that does not match the expected type.
  Data Entry Error: There may have been a mistake during data entry, leading to the assignment of an incorrect component type.
  Changes in Project Structure: