How To Fix SWL_WP048 - Segment number &1 of IP address "&2" is greater than 255

SAP Error Message - Details

• Message type: E = Error

• Message class: SWL_WP - Message for Workflow in Workplace

• Message number: 048

• Message text: Segment number &1 of IP address "&2" is greater than 255

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SWL_WP048 - Segment number &1 of IP address "&2" is greater than 255 ?

  The SAP error message SWL_WP048 indicates that there is an issue with an IP address format in the system. Specifically, the error states that one of the segments of the IP address is greater than 255, which is not valid since each segment of an IPv4 address must be in the range of 0 to 255.
  Cause:
  The error is caused by an invalid IP address format where one or more segments exceed the maximum allowable value of 255. An IP address consists of four segments (octets), and each segment is separated by a dot (e.g., 192.168.1.1). If any segment is greater than 255, it will trigger this error.
  Solution:
  To resolve this error, you should:
  
  
  Identify the IP Address: Check the IP address mentioned in the error message (in this case, &2 will be replaced with the actual IP address).
  
  
  Validate the Segments: Break down the IP address into its four segments and verify that each segment is within the range of 0 to 255.
  
  
  Correct the IP Address: If you find any segment greater than 255, correct it to a valid value. Ensure that the IP address conforms to the standard IPv4 format.
  
  
  Update Configuration: If the IP address is part of a configuration in SAP (e.g., in a network configuration, RFC destination, or other settings), update the configuration with the corrected IP address.
  
  
  Test the Changes: After making the necessary corrections, test the system or process that was generating the error to ensure that it is resolved.
  
  
  Related Information:
  
  IP Address Format: An IPv4 address consists of four decimal numbers (0-255) separated by dots. For example, 192.168.0.1 is a valid IP address.
  Common Causes of Invalid IP Addresses: This error can occur due to manual entry errors, incorrect configurations, or data imported from external sources that may not have been validated.
  SAP Documentation: For further details, you can refer to SAP's official documentation or support notes related to network configuration and error handling.
  
  If the issue persists after correcting the IP address, consider checking for any related configurations or consulting with your SAP Basis team for further assistance.