How To Fix SWDP_WB_TOOL163 - Breakpoint set for user &1

SAP Error Message - Details

• Message type: E = Error

• Message class: SWDP_WB_TOOL - Web Dynpro: Messages for Workbench Tools

• Message number: 163

• Message text: Breakpoint set for user &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SWDP_WB_TOOL163 - Breakpoint set for user &1 ?

  The SAP error message SWDP_WB_TOOL163, which states "Breakpoint set for user &1," typically occurs in the context of debugging within the SAP Web Dynpro environment. This message indicates that a breakpoint has been set for a specific user, which can interrupt the normal execution of the application.
  Cause:
  
  Debugging Mode: The error usually arises when a developer or user has set a breakpoint in the Web Dynpro application for a specific user. This can happen if the application is being debugged, and the debugger is paused at a breakpoint.
  User-Specific Breakpoints: The message indicates that the breakpoint is associated with a specific user, which means that the debugging session is tied to that user's session.
  
  Solution:
  
  
  Remove Breakpoints: If you are a developer, you can remove the breakpoints that have been set in the Web Dynpro application. This can be done in the ABAP Workbench (SE80) or the debugger itself.
  
  Go to the debugger and check for any active breakpoints.
  Remove or deactivate the breakpoints that are causing the issue.
  
  
  
  Check User-Specific Settings: If you are not the one who set the breakpoint, check with your development team to see if they have set any breakpoints for your user ID. They may need to remove or adjust these breakpoints.
  
  
  Switch to Normal Mode: If you are in debugging mode, switch back to normal execution mode to avoid interruptions caused by breakpoints.
  
  
  Consult Documentation: If you are unsure about how to proceed, refer to SAP documentation or consult with your SAP Basis or development team for assistance.
  
  
  Related Information:
  
  Debugging in SAP: Understanding how to use the debugger effectively can help prevent issues related to breakpoints. Familiarize yourself with the debugging tools available in SAP.
  User Management: Ensure that user roles and permissions are correctly set up to avoid unauthorized access to debugging features.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  If the issue persists after trying the above solutions, it may be beneficial to reach out to SAP support or your internal SAP support team for further assistance.