How To Fix SWDP_WB_CHIP028 - Select a port

SAP Error Message - Details

• Message type: E = Error

• Message class: SWDP_WB_CHIP - Message Class

• Message number: 028

• Message text: Select a port

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SWDP_WB_CHIP028 - Select a port ?

  The SAP error message SWDP_WB_CHIP028: Select a port typically occurs in the context of SAP Web Dynpro applications, particularly when working with the Web Dynpro Component Interface (WDCI) or when trying to configure a Web Dynpro component.
  Cause:
  This error usually indicates that the system is expecting you to select a port (which is a specific interface or connection point) for a Web Dynpro component, but none has been selected. Ports are essential for defining how components communicate with each other, and if a port is not selected, the system cannot proceed with the operation.
  Solution:
  To resolve this error, follow these steps:
  
  
  Open the Web Dynpro Component: Navigate to the Web Dynpro component that is causing the error.
  
  
  Check the Configuration: Ensure that you are in the correct configuration view where you can select the ports.
  
  
  Select a Port:
  
  Look for a section labeled "Ports" or "Interface" in the configuration.
  You should see a list of available ports. Select the appropriate port that corresponds to the functionality you are trying to implement.
  
  
  
  Save Changes: After selecting the port, make sure to save your changes.
  
  
  Test the Application: After saving, try to run or test the application again to see if the error persists.
  
  
  Related Information:
  
  Web Dynpro Components: Understanding how Web Dynpro components interact with each other through ports is crucial. Each component can have multiple ports for different interfaces.
  Documentation: Refer to SAP documentation or help resources for detailed information on configuring Web Dynpro components and managing ports.
  SAP Notes: Check for any relevant SAP Notes that might address specific issues related to this error message or provide additional troubleshooting steps.
  
  If the problem persists after following these steps, consider reaching out to your SAP support team or consulting the SAP Community for further assistance.