How To Fix SRT_WSP2831 - Name is too long. Restrict name to '&1' characters.

SAP Error Message - Details

• Message type: E = Error

• Message class: SRT_WSP2 - Messages for SRT WSP

• Message number: 831

• Message text: Name is too long. Restrict name to '&1' characters.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SRT_WSP2831 - Name is too long. Restrict name to '&1' characters. ?

  The SAP error message SRT_WSP2831 indicates that a name (likely a service name, endpoint, or similar identifier) exceeds the maximum allowed length defined by the system. The message specifies that the name must be restricted to a certain number of characters, denoted by &1.
  Cause:
  This error typically occurs when:
  
  You are trying to create or modify a service or endpoint in SAP that has a name longer than the allowed limit.
  The name might be a part of a web service, RFC destination, or other configuration settings within SAP.
  The system has specific constraints on the length of identifiers, and the provided name exceeds these constraints.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Identify the Name: Determine which name is causing the error. This could be in a configuration screen, service definition, or other areas where names are defined.
  
  
  Shorten the Name: Modify the name to ensure it adheres to the character limit specified in the error message. For example, if the error states that the name must be restricted to 30 characters, ensure that the name you are using is 30 characters or fewer.
  
  
  Check Documentation: Refer to SAP documentation or the specific module's guidelines to understand the naming conventions and limits for the particular service or configuration you are working with.
  
  
  Test Changes: After making the necessary changes, attempt to save or activate the configuration again to see if the error persists.
  
  
  Consult SAP Notes: If the issue continues, check SAP Notes or the SAP Community for any known issues or additional guidance related to this error message.
  
  
  Related Information:
  
  SAP Web Services: If you are working with web services, ensure that the service names and endpoint URLs conform to the naming conventions and length restrictions.
  Transaction Codes: Depending on where you encounter this error, you may be using transaction codes like SOAMANAGER, SE80, or others related to service management.
  SAP Version: Be aware that different versions of SAP may have different limits and naming conventions, so ensure you are referencing the correct version of the documentation.
  
  By following these steps, you should be able to resolve the SRT_WSP2831 error and successfully configure your service or endpoint in SAP.