How To Fix SRT_WSP2801 - Implementing Class '&1' for IBC Reveiver Type '&2' is missing

SRT_WSP2801 - Overview

• Message type: E = Error

• Message class: SRT_WSP2 - Messages for SRT WSP

• Message number: 801

• Message text: Implementing Class '&1' for IBC Reveiver Type '&2' is missing

What causes this issue?

The implementing class is missing for the receiver type of the ibc

System Response

The system is not able to check the IBC against the application but
continues to work

How to fix this error?

In case the class is part of a SAP standard application create a ticket
on the application component shown in the IBC in transaction SOAManager.
In case of a custom development contact your responsible organization.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SRT_WSP2801 - Implementing Class '&1' for IBC Reveiver Type '&2' is missing ?

  The SAP error message SRT_WSP2801 indicates that there is a missing implementation for a specific class that is required for the Integration Broker Communication (IBC) receiver type. This typically occurs in scenarios involving web services or when using SAP Process Integration (PI) or SAP Process Orchestration (PO).
  
  Cause:
  The error is caused by the absence of the implementing class for the specified IBC receiver type. This can happen due to several reasons:
  
  The required class has not been implemented or activated in the system.
  There may be a configuration issue where the receiver type is not correctly set up.
  The necessary software components or packages are not installed or are not up to date.
  There could be a typo or misconfiguration in the receiver type settings.
  
  
  Solution:
  To resolve the error, you can follow these steps:
  
  
  Check Implementation:
  
  Verify if the implementing class for the specified IBC receiver type exists in the system. You can do this by checking the