How To Fix SP050 - No withdrawal sequence groups found to convert

SAP Error Message - Details

• Message type: E = Error

• Message class: SP - Logistics: stock determination

• Message number: 050

• Message text: No withdrawal sequence groups found to convert

What causes this issue?

Either no withdrawal sequence groups (table T437S) or no plants could
be found for your selection criteria.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

INCLUDE NA_EINGABE_PRUEFEN

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SP050 - No withdrawal sequence groups found to convert ?

  The SAP error message SP050, which states "No withdrawal sequence groups found to convert," typically occurs in the context of inventory management or material requirements planning (MRP) when the system is unable to find the necessary withdrawal sequence groups for a specific material or process. This can happen during various transactions, such as when trying to perform a goods movement or when executing MRP runs.
  Causes:
  
  Missing Configuration: The withdrawal sequence groups may not be configured in the system for the specific material or plant.
  Material Master Data Issues: The material master may not have the necessary data filled in, such as the withdrawal sequence or storage location.
  Plant or Storage Location Settings: The plant or storage location settings may not be correctly defined, leading to the absence of withdrawal sequences.
  Data Inconsistencies: There may be inconsistencies or missing data in the related master data or configuration settings.
  
  Solutions:
  
  
  Check Material Master Data:
  
  Go to the material master (transaction code MM03) and check the relevant views (e.g., MRP, Plant Data/Storage).
  Ensure that the withdrawal sequence group is correctly assigned.
  
  
  
  Review Configuration:
  
  Use transaction code SPRO to access the configuration settings.
  Navigate to the relevant sections for inventory management and check if the withdrawal sequence groups are defined correctly.
  Ensure that the necessary settings for the plant and storage location are in place.
  
  
  
  Define Withdrawal Sequence Groups:
  
  If the withdrawal sequence groups are missing, you may need to create them. This can typically be done in the configuration settings under Inventory Management.
  Define the withdrawal sequence groups and assign them to the relevant materials.
  
  
  
  Check for Data Consistency:
  
  Run consistency checks on the material master and related data to identify any discrepancies.
  Use transaction codes like MM02 to make necessary adjustments.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on withdrawal sequence groups and their configuration.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: MM03 (Display Material), MM02 (Change Material), SPRO (Customizing).
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  User Forums: Engage with SAP community forums or user groups for shared experiences and solutions related to this error.
  
  By following these steps, you should be able to identify the cause of the SP050 error and implement the necessary solutions to resolve it.