How To Fix SOI_REPLICATOR185 - Table &1 trigger mode is &2. Replay is no longer needed.

SAP Error Message - Details

• Message type: E = Error

• Message class: SOI_REPLICATOR - Messages for SOI replicator

• Message number: 185

• Message text: Table &1 trigger mode is &2. Replay is no longer needed.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SOI_REPLICATOR185 - Table &1 trigger mode is &2. Replay is no longer needed. ?

  The SAP error message SOI_REPLICATOR185 indicates that there is an issue related to the replication of data in the SAP System Landscape Transformation (SLT) or SAP HANA Smart Data Integration (SDI) environment. This specific error message suggests that the trigger mode for a particular table has changed, and as a result, the replay of data is no longer necessary.
  Cause:
  
  Trigger Mode Change: The error typically occurs when the trigger mode for a table has been altered. This can happen if the table is switched from a mode that requires replication (like "Log-based" or "Trigger-based") to a mode that does not require it (like "Full Load" or "No Replication").
  Configuration Changes: Changes in the configuration of the SLT or SDI settings can lead to this error. For example, if the replication settings for a table are modified, it may lead to this message.
  Data Consistency Issues: If there are inconsistencies in the data or if the replication process has been interrupted, it may trigger this error.
  
  Solution:
  
  Check Trigger Mode: Verify the current trigger mode for the affected table. You can do this by checking the SLT configuration or the relevant settings in the SAP HANA studio.
  Adjust Configuration: If the trigger mode has been changed unintentionally, revert it back to the required mode that supports replication.
  Restart Replication: If the replication process has been interrupted, you may need to restart the replication for the affected table. This can often be done through the SLT or SDI administration interface.
  Monitor Logs: Check the logs for any additional error messages or warnings that may provide more context about the issue. This can help in diagnosing the root cause.
  Consult Documentation: Refer to the official SAP documentation for SLT or SDI for detailed instructions on managing replication settings and troubleshooting common issues.
  
  Related Information:
  
  SAP Notes: Look for relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  SLT/SDI Documentation: Review the official SAP documentation for SLT or SDI for best practices on configuring replication and managing trigger modes.
  Community Forums: Engage with the SAP Community or forums where other users may have encountered similar issues and can share their solutions.
  
  If the problem persists after following these steps, consider reaching out to SAP support for further assistance.