How To Fix SMT_CONFIG118 - Structure &1 is already specified as an additional structure

SAP Error Message - Details

• Message type: E = Error

• Message class: SMT_CONFIG - Configuration message class

• Message number: 118

• Message text: Structure &1 is already specified as an additional structure

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SMT_CONFIG118 - Structure &1 is already specified as an additional structure ?

  The SAP error message SMT_CONFIG118 indicates that there is an issue with the configuration of structures in the SAP system, specifically that a structure is being defined more than once as an additional structure in a certain context (like in a mapping or transformation).
  Cause:
  This error typically occurs when:
  
  You are trying to add a structure to a configuration that has already been defined as an additional structure.
  There may be a duplicate entry in the configuration settings where the same structure is being referenced multiple times.
  The configuration might be incorrectly set up, leading to conflicts in the definitions.
  
  Solution:
  To resolve the SMT_CONFIG118 error, you can follow these steps:
  
  
  Check Configuration: 
  
  Go to the relevant configuration area (like the mapping or transformation settings) where the error is occurring.
  Look for the structure that is causing the issue (indicated by &1 in the error message).
  Ensure that the structure is only defined once as an additional structure.
  
  
  
  Remove Duplicates:
  
  If you find that the structure is listed multiple times, remove the duplicate entries.
  Make sure that each structure is only added once to avoid conflicts.
  
  
  
  Review Dependencies:
  
  Check if there are any dependencies or related configurations that might be causing the structure to be referenced multiple times.
  Ensure that all related configurations are consistent and do not lead to duplication.
  
  
  
  Test Configuration:
  
  After making the necessary changes, test the configuration to ensure that the error is resolved.
  If the error persists, double-check the entire configuration for any overlooked duplicates.
  
  
  
  Consult Documentation:
  
  If you are unsure about the configuration settings, refer to SAP documentation or help resources for guidance on how to properly configure additional structures.
  
  
  
  Seek Help:
  
  If you are unable to resolve the issue, consider reaching out to your SAP support team or consulting with an SAP expert who can provide more specific assistance based on your system setup.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Transaction Codes: Familiarize yourself with transaction codes related to the configuration you are working on (e.g., SMT1 for mapping).
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify and resolve the SMT_CONFIG118 error in your SAP system.