How To Fix /SMB/BB_INSTALLER186 - Nothing changed

SAP Error Message - Details

• Message type: E = Error

• Message class: /SMB/BB_INSTALLER -

• Message number: 186

• Message text: Nothing changed

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SMB/BB_INSTALLER186 - Nothing changed ?

  The SAP error message /SMB/BB_INSTALLER186 Nothing changed typically occurs during the installation or upgrade of the SAP Business ByDesign (ByD) solution. This message indicates that the system has detected no changes in the configuration or data that would require an update or installation process to proceed.
  Causes:
  
  No Configuration Changes: The most common cause is that there have been no changes made to the configuration or settings that would necessitate an update.
  Incomplete Installation Steps: If the installation or upgrade process was not completed correctly, it might lead to this message.
  Caching Issues: Sometimes, caching mechanisms can cause the system to not recognize changes that have been made.
  Version Compatibility: If the version of the software being installed is not compatible with the existing system, it may lead to this error.
  
  Solutions:
  
  Verify Changes: Ensure that there are actual changes made in the configuration or data that should trigger the installation process. If no changes are needed, you can safely ignore this message.
  Re-run the Installation: If you believe changes were made but the system is not recognizing them, try re-running the installation or upgrade process.
  Clear Cache: If caching is suspected to be an issue, clear the cache of the application or the browser (if applicable) and try again.
  Check Logs: Review the installation logs for any additional error messages or warnings that might provide more context on why the installation is not proceeding.
  Consult Documentation: Refer to the official SAP documentation for any specific instructions or prerequisites related to the installation or upgrade process.
  Contact SAP Support: If the issue persists and you cannot identify the cause, consider reaching out to SAP support for assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error message or provide additional troubleshooting steps.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  System Requirements: Ensure that your system meets all the necessary requirements for the installation or upgrade you are attempting.
  
  By following these steps, you should be able to address the /SMB/BB_INSTALLER186 Nothing changed error effectively.