How To Fix SIC_NORM_CONFIG030 - Class &1 not assigned to a basic rule type

SAP Error Message - Details

• Message type: E = Error

• Message class: SIC_NORM_CONFIG - Message for Configurtion of Normalization Service

• Message number: 030

• Message text: Class &1 not assigned to a basic rule type

What causes this issue?

Class &V1& is not assigned to a basic rule type.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Check the settings for the basic rule types and assign them if required.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SIC_NORM_CONFIG030 - Class &1 not assigned to a basic rule type ?

  The SAP error message SIC_NORM_CONFIG030 indicates that a specific class (denoted as &1 in the error message) is not assigned to a basic rule type in the SAP system. This error typically arises in the context of SAP's normalization and classification processes, often related to the SAP Information Lifecycle Management (ILM) or similar modules.
  Cause:
  The primary cause of this error is that the specified class has not been properly configured or linked to a basic rule type in the system. This can happen due to:
  
  Missing Configuration: The class may not have been assigned to any basic rule type during the setup process.
  Incorrect Class Definition: The class might not be defined correctly in the system.
  Changes in Configuration: If there have been recent changes to the configuration or updates to the system, it might have led to the disassociation of the class from the basic rule type.
  
  Solution:
  To resolve the error, you can follow these steps:
  
  
  Check Class Assignment:
  
  Go to the configuration settings for the normalization or classification process in SAP.
  Verify if the class mentioned in the error message is assigned to a basic rule type.
  
  
  
  Assign Class to Basic Rule Type:
  
  If the class is not assigned, you will need to assign it to the appropriate basic rule type.
  This can typically be done in the customizing settings (transaction code SPRO) under the relevant module (e.g., ILM).
  
  
  
  Review Class Definition:
  
  Ensure that the class is correctly defined and meets all necessary criteria for assignment to a basic rule type.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific instructions on how to configure classes and basic rule types.
  
  
  
  Testing:
  
  After making the necessary changes, test the configuration to ensure that the error no longer occurs.
  
  
  
  Transport Changes:
  
  If you are working in a development environment, ensure that any changes are transported to the production environment as needed.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO for configuration, SICF for service activation, or SICN for normalization settings.
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message.
  Support: If the issue persists, consider reaching out to SAP support or consulting with an SAP expert who specializes in the relevant module.
  
  By following these steps, you should be able to resolve the SIC_NORM_CONFIG030 error and ensure that your class is properly configured within the SAP system.