How To Fix SE758 - Model service specs. & cannot be configured (no object dependencies)

SAP Error Message - Details

• Message type: E = Error

• Message class: SE - Dienstleistungen Stammdaten Leistungsposition

• Message number: 758

• Message text: Model service specs. & cannot be configured (no object dependencies)

What causes this issue?

In the header of the model service specifications it has been
stipulated that the latter are to be configured.
However no object dependencies have been maintained for the service
lines.
Configuration is therefore not possible.

System Response

How to fix this error?

Maintain object dependencies in the model specifications or stipulate
in the header that these specifications are not to be configured.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SE758 - Model service specs. & cannot be configured (no object dependencies) ?

  The SAP error message SE758, which states "Model service specs. & cannot be configured (no object dependencies)," typically occurs in the context of variant configuration in SAP. This error indicates that the system is unable to configure a model because there are no object dependencies defined for it. Object dependencies are essential in variant configuration as they determine how the characteristics and values of a product relate to each other.
  Cause:
  
  Missing Object Dependencies: The primary cause of this error is that the model does not have any object dependencies defined. Object dependencies can include preconditions, selection conditions, and procedures that guide the configuration process.
  Incorrect Model Setup: The model may not be set up correctly in the system, leading to the absence of necessary dependencies.
  Configuration Profile Issues: There may be issues with the configuration profile assigned to the model, which could prevent the system from recognizing the dependencies.
  
  Solution:
  
  
  Define Object Dependencies:
  
  Go to the transaction code CU01 (Create Object Dependency) or CU02 (Change Object Dependency) in SAP.
  Create or modify the necessary object dependencies for the model. Ensure that you define the relevant characteristics and their relationships.
  
  
  
  Check Model Configuration:
  
  Verify that the model is correctly configured in the system. Check the model's settings in transaction CU50 (Model Configuration) to ensure that it is set up properly.
  
  
  
  Review Configuration Profile:
  
  Ensure that the configuration profile assigned to the model is correct and that it includes the necessary dependencies. You can check this in transaction CU41 (Maintain Configuration Profile).
  
  
  
  Test Configuration:
  
  After defining the object dependencies, test the configuration again to see if the error persists. Use transaction CU50 to attempt to configure the model.
  
  
  
  Consult Documentation:
  
  If you are unsure about how to define object dependencies or configure the model, refer to SAP documentation or consult with a colleague who has experience in variant configuration.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  CU01: Create Object Dependency
  CU02: Change Object Dependency
  CU50: Model Configuration
  CU41: Maintain Configuration Profile
  
  
  
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to variant configuration and object dependencies.
  
  
  Training and Resources: Consider SAP training resources or courses on variant configuration to better understand how to set up models and dependencies effectively.
  
  
  By following these steps, you should be able to resolve the SE758 error and successfully configure your model in SAP.