How To Fix SDS_COMMON020 - Block size of &1 is to large; enter a value between &2 and &3

SAP Error Message - Details

• Message type: E = Error

• Message class: SDS_COMMON -

• Message number: 020

• Message text: Block size of &1 is to large; enter a value between &2 and &3

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SDS_COMMON020 - Block size of &1 is to large; enter a value between &2 and &3 ?

  The SAP error message SDS_COMMON020 indicates that the block size specified for a certain operation is too large. This error typically occurs when the block size exceeds the maximum limit defined by the system or when it is below the minimum required size.
  Cause:
  
  Block Size Exceeded: The value entered for the block size is greater than the maximum allowed limit (&3).
  Block Size Too Small: The value entered is less than the minimum required limit (&2).
  Configuration Issues: The system configuration may not be set up correctly, leading to incorrect limits being applied.
  
  Solution:
  
  Check Limits: Review the error message to identify the minimum (&2) and maximum (&3) allowed block sizes. Ensure that the value you are trying to enter falls within this range.
  Adjust Block Size: Enter a new block size that is within the specified limits. For example, if the error message states that the block size must be between 10 and 100, you should enter a value like 50.
  Review Configuration: If you believe the limits are incorrect, consult with your SAP Basis or system administrator to review the configuration settings related to block sizes.
  Documentation: Refer to SAP documentation or help resources for specific details about the context in which this error occurs, as it may vary depending on the module or transaction you are using.
  
  Related Information:
  
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message.
  Transaction Codes: If this error occurs in a specific transaction, look for transaction codes related to that process to find more context.
  Community Forums: SAP Community and other forums can provide insights from other users who may have encountered the same issue.
  
  If the problem persists after following these steps, consider reaching out to SAP support for further assistance.