How To Fix SCWN614 - Parameter &1 for function module &2 already exists

SCWN614 - Overview

• Message type: E = Error

• Message class: SCWN - Messages Note installation and management

• Message number: 614

• Message text: Parameter &1 for function module &2 already exists

What causes this issue?

You are attempting to create a parameter that already exists for this
function module.

System Response

The function terminates.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

SCWN614 - Details

• The SAP error message SCWN614 indicates that there is an attempt to create or define a parameter in a function module that already exists. This typically occurs during the development or modification of function modules in the SAP system.
  
  Cause:
  The error is caused by one of the following reasons:
  
  Duplicate Parameter Definition: You are trying to define a parameter (input, output, or changing) in a function module that has the same name as an existing parameter.
  Incorrect Function Module Modification: If you are modifying an existing function module, you might inadvertently try to add a parameter that already exists in the function module's interface.
  Copying Function Modules: If you copied a function module and did not change the parameter names, this error can occur.
  
  
  Solution:
  To resolve the SCWN614 error, you can follow these steps:
  
  
  Check Parameter Names: Review the parameters defined in the function module. Ensure that the parameter you are trying to add does not