How To Fix SCWN361 - & & cannot be selected (it is already part of the applied changes)

SCWN361 - Overview

• Message type: E = Error

• Message class: SCWN - Messages Note installation and management

• Message number: 361

• Message text: & & cannot be selected (it is already part of the applied changes)

What causes this issue?

You have specified &V1& &V2& as the target of changes. However, this
object is already part of the current changes, meaning that the
Correction Workbench attempts to mix into this object changes from a
different source.

System Response

You cannot specify &V1& &V2& as a target include.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SCWN361 - & & cannot be selected (it is already part of the applied changes) ?

  The SAP error message SCWN361 typically indicates that a certain object or change cannot be selected because it is already part of the applied changes in the system. This error often arises in the context of transport requests or change management processes within SAP.
  
  Cause:
  
  Duplicate Selection: The object you are trying to select has already been included in a transport request or change request that has been applied to the system.
  Transport Request Status: The transport request may be in a status that does not allow further modifications or selections.
  Change Management: The object might be locked or in use by another process, preventing it from being selected again.
  
  
  Solution:
  
  Check Transport Requests: Review the transport requests in the system to see if the object is already included. You can do this using transaction codes like SE01 (Transport Organizer) or SE09 (Workbench Organizer).
  Release Transport Requests: If the transport request is in a modifiable state, consider