How To Fix /SCWM/UI_TODLV004 - Unit of measure was reset

SAP Error Message - Details

• Message type: E = Error

• Message class: /SCWM/UI_TODLV -

• Message number: 004

• Message text: Unit of measure was reset

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCWM/UI_TODLV004 - Unit of measure was reset ?

  The SAP error message /SCWM/UI_TODLV004 Unit of measure was reset typically occurs in the context of the Extended Warehouse Management (EWM) module when there is an issue with the unit of measure (UoM) during the handling of a delivery or warehouse task. This error indicates that the system has reset the unit of measure for a particular item, which can lead to inconsistencies in processing.
  Causes:
  
  Inconsistent UoM Settings: The unit of measure defined for the material in the system may not match the expected unit of measure for the delivery or task.
  Conversion Issues: There may be issues with the conversion factors between different units of measure, leading to the system resetting the UoM.
  Data Entry Errors: Manual entry errors during the creation of the delivery or warehouse task can lead to incorrect UoM being assigned.
  Configuration Issues: Incorrect configuration in the material master or warehouse management settings can lead to this error.
  
  Solutions:
  
  Check Material Master Data: Verify the unit of measure settings in the material master. Ensure that the base unit of measure and alternative units of measure are correctly defined.
  Review Delivery and Task Data: Check the delivery or warehouse task data to ensure that the UoM being used is valid and consistent with the material master.
  Adjust Conversion Factors: If there are conversion factors defined, ensure they are correct and that they allow for the expected conversions between units of measure.
  Correct Data Entry: If the error was caused by manual data entry, correct the entries and reprocess the delivery or task.
  Consult Configuration Settings: Review the configuration settings in the EWM system to ensure that they are set up correctly for handling units of measure.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like /SCWM/PRDI (for processing inbound deliveries) or /SCWM/TO (for handling transfer orders) to investigate further.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on handling UoM issues in EWM.
  Documentation: Refer to the SAP EWM documentation for detailed information on unit of measure handling and configuration.
  
  If the issue persists after checking these areas, it may be beneficial to consult with your SAP support team or a technical consultant who specializes in EWM for further assistance.