How To Fix /SCWM/TDC153 - Edges &1 and &2 are less than &3 &4 apart

SAP Error Message - Details

• Message type: E = Error

• Message class: /SCWM/TDC -

• Message number: 153

• Message text: Edges &1 and &2 are less than &3 &4 apart

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCWM/TDC153 - Edges &1 and &2 are less than &3 &4 apart ?

  The SAP error message /SCWM/TDC153 Edges &1 and &2 are less than &3 &4 apart typically occurs in the context of warehouse management, particularly when dealing with the configuration of storage bins, handling units, or other spatial arrangements in the SAP Extended Warehouse Management (EWM) module.
  Cause:
  This error indicates that there is a spatial constraint violation. Specifically, it means that the edges of two objects (such as storage bins or handling units) are too close together, violating the minimum distance requirement set in the system. The placeholders &1, &2, &3, and &4 represent specific identifiers or measurements related to the objects in question.
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Configuration Settings: Review the configuration settings for the storage bins or handling units involved. Ensure that the minimum distance settings are correctly defined according to your warehouse layout and operational requirements.
  
  
  Adjust Bin Layout: If the error is due to the physical layout of the storage bins, consider adjusting the layout to ensure that the required distance between the edges of the bins is maintained.
  
  
  Review Handling Units: If the error involves handling units, check the dimensions and positioning of the handling units to ensure they comply with the spatial requirements.
  
  
  Consult Documentation: Refer to the SAP EWM documentation for guidelines on spatial constraints and how to configure them properly.
  
  
  Test Changes: After making adjustments, test the changes in a development or test environment before applying them to the production system.
  
  
  Seek Support: If the issue persists, consider reaching out to SAP support or consulting with an SAP EWM expert for further assistance.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  EWM Configuration Guides: Review the configuration guides for SAP EWM, which may provide insights into managing spatial constraints and optimizing warehouse layouts.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the root cause of the error and implement a suitable solution.