How To Fix /SCWM/TDC140 - The specified edge &1 is not assigned to the specified network

SAP Error Message - Details

• Message type: E = Error

• Message class: /SCWM/TDC -

• Message number: 140

• Message text: The specified edge &1 is not assigned to the specified network

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCWM/TDC140 - The specified edge &1 is not assigned to the specified network ?

  The SAP error message /SCWM/TDC140 indicates that there is an issue with the configuration of the transportation network in the SAP Extended Warehouse Management (EWM) system. Specifically, it means that the edge (which can refer to a transportation route or connection) you are trying to use is not assigned to the specified network.
  Cause:
  
  Missing Assignment: The edge you are trying to use has not been assigned to the transportation network you are working with.
  Incorrect Configuration: There may be a misconfiguration in the transportation network settings or the edge itself.
  Data Inconsistency: There could be inconsistencies in the master data related to the transportation network or edges.
  
  Solution:
  
  
  Check Edge Assignment:
  
  Go to the configuration settings for the transportation network in SAP EWM.
  Verify that the edge you are trying to use is correctly assigned to the specified network.
  If it is not assigned, you will need to assign it appropriately.
  
  
  
  Review Configuration:
  
  Ensure that the transportation network and edges are configured correctly in the system.
  Check for any missing or incorrect entries in the configuration.
  
  
  
  Data Consistency Check:
  
  Run consistency checks on the transportation network and edges to identify any discrepancies.
  Correct any inconsistencies found during the checks.
  
  
  
  Consult Documentation:
  
  Refer to the SAP EWM documentation for detailed steps on configuring transportation networks and edges.
  Ensure that you are following best practices for setting up these configurations.
  
  
  
  Testing:
  
  After making the necessary changes, test the configuration to ensure that the error does not occur again.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like /SCWM/TSN (Transportation Network) to access and modify the transportation network settings.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  Support: If the issue persists after following the above steps, consider reaching out to SAP support for further assistance.
  
  By following these steps, you should be able to resolve the error message /SCWM/TDC140 and ensure that your transportation network is configured correctly.