How To Fix /SCWM/SHP_RCV613 - Checkpoint for loading point &1 is not unique

SAP Error Message - Details

• Message type: E = Error

• Message class: /SCWM/SHP_RCV -

• Message number: 613

• Message text: Checkpoint for loading point &1 is not unique

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCWM/SHP_RCV613 - Checkpoint for loading point &1 is not unique ?

  The SAP error message /SCWM/SHP_RCV613 Checkpoint for loading point &1 is not unique typically occurs in the context of the Extended Warehouse Management (EWM) module when there is an issue with the configuration of loading points in the system. This error indicates that the system has found multiple checkpoints associated with the same loading point, which leads to ambiguity in processing.
  Cause:
  
  Duplicate Checkpoints: The primary cause of this error is the existence of multiple checkpoints defined for the same loading point in the system. This can happen due to incorrect configuration or data entry errors.
  Configuration Issues: If the loading points and their associated checkpoints are not set up correctly in the system, it can lead to this error.
  Data Consistency: There may be inconsistencies in the master data related to loading points and checkpoints.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Configuration:
  
  Go to the EWM configuration settings and navigate to the section where loading points and checkpoints are defined.
  Verify that each loading point has a unique checkpoint associated with it.
  
  
  
  Identify Duplicates:
  
  Use transaction codes like /SCWM/LOAD or relevant reports to list all loading points and their checkpoints.
  Look for any duplicates in the list and identify the loading point that is causing the issue.
  
  
  
  Correct Duplicates:
  
  If duplicates are found, you will need to either delete or modify the duplicate entries to ensure that each loading point has a unique checkpoint.
  Make sure to save your changes and transport them if necessary.
  
  
  
  Data Consistency Check:
  
  Run data consistency checks in EWM to ensure that all configurations are correct and that there are no other related issues.
  
  
  
  Testing:
  
  After making the necessary changes, test the loading process again to ensure that the error no longer occurs.
  
  
  
  Related Information:
  
  Documentation: Refer to SAP EWM documentation for detailed information on configuring loading points and checkpoints.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after following the above steps, consider reaching out to SAP support for further assistance.
  
  By ensuring that each loading point has a unique checkpoint and correcting any configuration issues, you should be able to resolve the error message /SCWM/SHP_RCV613.