How To Fix /SCWM/LT078 - End value cannot be reached with this start value and increment

/SCWM/LT078 - Overview

• Message type: E = Error

• Message class: /SCWM/LT -

• Message number: 078

• Message text: End value cannot be reached with this start value and increment

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

/SCWM/LT078 - Details

• The SAP error message /SCWM/LT078 indicates that there is an issue with the values specified for a task in the Warehouse Management (WM) or Extended Warehouse Management (EWM) module. Specifically, it means that the end value cannot be reached from the start value using the specified increment. This typically occurs in scenarios involving picking, putaway, or inventory tasks where the system is trying to calculate a range of values based on the provided parameters.
  
  Cause:
  
  Incorrect Start and End Values: The start value is set higher than the end value, or the increment is too large to reach the end value from the start value.
  Invalid Increment: The increment value may be set to zero or a negative number, which would prevent the calculation from progressing towards the end value.
  
  Configuration Issues: There may be issues with the configuration of the warehouse or the specific task being executed, leading to incorrect value settings.
  
  
  Solution:
  
  
  Check Values: