How To Fix /SCWM/HUGENERAL046 - Quantity cannot be rounded off for unit of measure &1

SAP Error Message - Details

• Message type: E = Error

• Message class: /SCWM/HUGENERAL -

• Message number: 046

• Message text: Quantity cannot be rounded off for unit of measure &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCWM/HUGENERAL046 - Quantity cannot be rounded off for unit of measure &1 ?

  The SAP error message /SCWM/HUGENERAL046 indicates that there is an issue with rounding off quantities for a specific unit of measure (UoM) in the SAP Extended Warehouse Management (EWM) module. This error typically arises when the system is unable to convert or round the quantity to the required UoM due to the defined conversion factors or the nature of the UoM itself.
  Cause:
  
  Incompatible UoM Conversion: The quantity being processed cannot be converted to the target UoM because the conversion factor is not defined correctly or does not allow for the required rounding.
  Decimal Places: The quantity may have more decimal places than allowed for the target UoM, leading to rounding issues.
  Configuration Issues: There may be configuration issues in the material master or UoM settings that prevent proper conversion.
  Negative Quantities: If the quantity is negative, it may not be possible to round it off correctly.
  
  Solution:
  
  Check UoM Settings: Review the unit of measure settings in the material master. Ensure that the conversion factors between the base UoM and the target UoM are defined correctly.
  Adjust Decimal Places: If the quantity has too many decimal places, consider adjusting the quantity to fit within the allowed decimal places for the target UoM.
  Review Material Master: Go to the material master record and check the UoM settings. Ensure that the UoM is set up correctly and that the conversion factors are appropriate.
  Check for Negative Quantities: Ensure that the quantity being processed is not negative, as this can lead to rounding issues.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidelines on UoM conversions and rounding rules.
  Testing: If changes are made, test the process again to ensure that the error does not recur.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like MM02 (Change Material) to check and modify the material master data.
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide additional guidance on this error.
  User Exits or BAdIs: If custom logic is implemented, review any user exits or BAdIs that may affect UoM handling.
  Support: If the issue persists, consider reaching out to SAP support for further assistance.
  
  By following these steps, you should be able to identify the root cause of the error and implement a solution to resolve it.