How To Fix /SCWM/DS_CORE138 - Loading point &1 and docking location &2 not found

SAP Error Message - Details

• Message type: E = Error

• Message class: /SCWM/DS_CORE -

• Message number: 138

• Message text: Loading point &1 and docking location &2 not found

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCWM/DS_CORE138 - Loading point &1 and docking location &2 not found ?

  The SAP error message /SCWM/DS_CORE138 Loading point &1 and docking location &2 not found typically occurs in the context of the SAP Extended Warehouse Management (EWM) module. This error indicates that the system is unable to find the specified loading point and docking location in the warehouse management system.
  Causes:
  
  Incorrect Configuration: The loading point or docking location may not be properly configured in the system.
  Data Entry Errors: There may be a typo or incorrect entry when specifying the loading point or docking location.
  Master Data Issues: The loading point or docking location may not exist in the master data or may have been deleted or deactivated.
  Transport Issues: If the data was recently transported from another system, the loading point or docking location may not have been included in the transport.
  
  Solutions:
  
  
  Check Configuration:
  
  Navigate to the configuration settings for loading points and docking locations in SAP EWM.
  Ensure that the loading point and docking location are correctly defined and active.
  
  
  
  Verify Master Data:
  
  Go to the master data section in SAP EWM and check if the loading point and docking location exist.
  If they do not exist, create them as needed.
  
  
  
  Correct Data Entry:
  
  Double-check the entries for loading point and docking location in the transaction or process where the error occurred.
  Ensure that there are no typos or incorrect values.
  
  
  
  Transport Check:
  
  If the issue arose after a transport, verify that the loading point and docking location were included in the transport request.
  If they were not, you may need to transport them again or create them manually in the target system.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help resources for additional guidance on loading points and docking locations.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like /SCWM/LOC to manage locations or /SCWM/LP to manage loading points.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Roles: Ensure that the user has the necessary permissions to access and modify loading points and docking locations.
  
  By following these steps, you should be able to identify and resolve the issue related to the error message /SCWM/DS_CORE138.