How To Fix /SCWM/CON185 - Determine width indicator - step not active

SAP Error Message - Details

• Message type: E = Error

• Message class: /SCWM/CON -

• Message number: 185

• Message text: Determine width indicator - step not active

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCWM/CON185 - Determine width indicator - step not active ?

  The SAP error message /SCWM/CON185 Determine width indicator - step not active typically occurs in the context of the Extended Warehouse Management (EWM) module. This error indicates that the system is unable to determine the width indicator for a specific process because the relevant step in the configuration is not active.
  Cause:
  
  Inactive Configuration Step: The error usually arises when a necessary configuration step related to the width indicator is not activated in the system. This could be due to missing settings in the warehouse process type or the warehouse management configuration.
  Missing Master Data: The required master data (like storage type, storage bin, or handling unit) may not be properly defined or activated.
  Process Type Issues: The process type being used may not have the necessary settings to determine the width indicator.
  
  Solution:
  
  
  Check Configuration:
  
  Go to the EWM configuration settings and verify that all necessary steps related to the width indicator are active. This can typically be found in the configuration for warehouse process types or storage types.
  Ensure that the relevant process types are correctly defined and activated.
  
  
  
  Review Master Data:
  
  Check the master data for the warehouse, including storage types and bins, to ensure that they are correctly set up and active.
  Make sure that the width indicator is defined for the relevant storage types or handling units.
  
  
  
  Activate Steps:
  
  If you identify any inactive steps in the configuration, activate them. This may involve going to the relevant customizing transaction (like SPRO) and navigating to the EWM settings.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific error message for additional guidance and troubleshooting steps.
  
  
  
  Testing:
  
  After making the necessary changes, test the process again to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like /SCWM/PRDI for process type configuration or /SCWM/MON for monitoring warehouse activities.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after checking the configuration and master data, consider reaching out to SAP support for further assistance.
  
  By following these steps, you should be able to resolve the error and ensure that the width indicator can be determined correctly in your EWM processes.