How To Fix /SCMTMS/EHS_DG_CHECK016 - &1: Item &2: Multipl. factor for DG product &3 should not be initial

/SCMTMS/EHS_DG_CHECK016 - Overview

• Message type: E = Error

• Message class: /SCMTMS/EHS_DG_CHECK -

• Message number: 016

• Message text: &1: Item &2: Multipl. factor for DG product &3 should not be initial

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SCMTMS/EHS_DG_CHECK016 - &1: Item &2: Multipl. factor for DG product &3 should not be initial ?

  The SAP error message /SCMTMS/EHS_DG_CHECK016 indicates that there is an issue with the dangerous goods (DG) product configuration in the SAP system. Specifically, the error message states that the multiplication factor for a dangerous goods product should not be initial (i.e., it should have a value).
  
  Cause:
  The error is typically caused by one of the following reasons:
  
  Missing Data: The multiplication factor for the dangerous goods product is not defined in the system. This could happen if the product was not properly configured or if the necessary data was not entered during the product setup.
  Incorrect Configuration: The dangerous goods settings for the product may not have been fully completed, leading to missing or incomplete information.
  Data Migration Issues: If data was migrated from another system, there may have been issues that resulted in missing values for the multiplication factor.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Product Configuration:
  
  Go to the relevant