How To Fix SCM_MD_R3_PI024 - You can only define one parallel unit of measure

SAP Error Message - Details

• Message type: E = Error

• Message class: SCM_MD_R3_PI - SCM Master Data in Plug-In

• Message number: 024

• Message text: You can only define one parallel unit of measure

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SCM_MD_R3_PI024 - You can only define one parallel unit of measure ?

  The SAP error message SCM_MD_R3_PI024, which states "You can only define one parallel unit of measure," typically occurs in the context of SAP Advanced Planning and Optimization (APO) or SAP Supply Chain Management (SCM) when there is an issue with the configuration of units of measure for a material.
  Cause:
  This error arises when you attempt to define multiple parallel units of measure for a material in a way that is not allowed by the system. In SAP, a parallel unit of measure is an additional unit of measure that can be used alongside the base unit of measure for a material. However, the system restricts the definition to only one parallel unit of measure to avoid confusion and ensure consistency in inventory management and planning.
  Solution:
  To resolve this error, you need to check the configuration of the material in question and ensure that only one parallel unit of measure is defined. Here are the steps you can take:
  
  
  Access Material Master Data:
  
  Go to the transaction code MM02 (Change Material) or MM03 (Display Material) in SAP.
  Enter the material number that is causing the error.
  
  
  
  Check Units of Measure:
  
  Navigate to the "Basic Data" or "Sales Org. Data" views, depending on where the parallel unit of measure is defined.
  Look for the section where units of measure are defined.
  
  
  
  Review Parallel Unit of Measure:
  
  Identify if there are multiple parallel units of measure defined for the material.
  If there are, you will need to remove the additional parallel unit of measure, leaving only one.
  
  
  
  Save Changes:
  
  After making the necessary adjustments, save the changes to the material master data.
  
  
  
  Test the Changes:
  
  After saving, try to perform the action that previously triggered the error to ensure that it has been resolved.
  
  
  
  Related Information:
  
  Unit of Measure Configuration: Understanding how units of measure work in SAP is crucial. You can refer to SAP documentation or training materials on material master data and units of measure.
  SAP Notes: Check for any relevant SAP Notes that might provide additional insights or updates related to this error message.
  User Authorization: Ensure that you have the necessary authorizations to make changes to material master data.
  Consult with SAP Support: If the issue persists or if you are unsure about making changes, consider reaching out to your SAP support team or consulting with an SAP expert.
  
  By following these steps, you should be able to resolve the SCM_MD_R3_PI024 error and ensure that your material master data is correctly configured.