How To Fix SCI225 - Check category &2 for checking &1 is not yet active

SAP Error Message - Details

• Message type: E = Error

• Message class: SCI - Code Inspector

• Message number: 225

• Message text: Check category &2 for checking &1 is not yet active

What causes this issue?

The &V1& check was to be activated. However, the check category &V2& to
which it is assigned is not yet active.

System Response

The &V1& check cannot be activated.

How to fix this error?

First activate the check category &V2&.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SCI225 - Check category &2 for checking &1 is not yet active ?

  The SAP error message SCI225 indicates that a specific check category (denoted as &2) for a checking object (denoted as &1) is not yet active. This typically occurs in the context of SAP's checking framework, which is used for various validation and consistency checks in the system.
  Cause:
  The error usually arises due to one of the following reasons:
  
  Inactive Check Category: The check category that is supposed to be used for validation is not activated in the system. This can happen if the configuration for the check categories has not been completed or if the check has been deliberately deactivated.
  Configuration Issues: There may be issues in the configuration settings related to the specific check category or checking object.
  Transport Issues: If the configuration was transported from another system, it might not have been activated properly in the target system.
  
  Solution:
  To resolve the SCI225 error, you can follow these steps:
  
  
  Activate the Check Category:
  
  Go to the relevant configuration transaction in SAP (e.g., SPRO).
  Navigate to the section where the check categories are defined.
  Find the specific check category (&2) related to the checking object (&1) and ensure it is activated.
  
  
  
  Check Configuration:
  
  Review the configuration settings for the checking object and the associated check categories.
  Ensure that all necessary settings are correctly defined and activated.
  
  
  
  Transport Management:
  
  If the configuration was transported, check the transport logs to ensure that the transport was successful and that all necessary objects were included.
  If needed, re-transport the configuration or manually activate the check category in the target system.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific checking framework you are using. This can provide insights into any additional steps or considerations.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide specific notes or patches that address the issue.
  
  
  
  Related Information:
  
  Transaction Codes: Depending on the context, you may need to use transaction codes like SPRO (for configuration), SCDO (for check definitions), or others relevant to your specific SAP module.
  SAP Notes: Search for relevant SAP Notes in the SAP Support Portal that may address this specific error or provide additional troubleshooting steps.
  Documentation: Review the SAP Help Portal for documentation related to the specific module or functionality you are working with, as it may contain useful information regarding check categories and their activation.
  
  By following these steps, you should be able to identify the cause of the SCI225 error and implement the necessary solution to resolve it.