How To Fix SCDT_MPNG1008 - Internal error: No entry in &2 for object &1

SCDT_MPNG1008 - Overview

• Message type: E = Error

• Message class: SCDT_MPNG1 - Message Class for the Function Module scdt_mapping_check

• Message number: 008

• Message text: Internal error: No entry in &2 for object &1

What causes this issue?

There is no entry in &V2& for the object &V1&.
Object key: <mapping object>; <target system software component>;
<target from release>;
<source from release>; <table name>;

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SCDT_MPNG1008 - Internal error: No entry in &2 for object &1 ?

  The SAP error message SCDT_MPNG1008 indicates an internal error where there is no entry found in a specific table for a given object. This error typically arises in the context of SAP's Supply Chain Management (SCM) or Advanced Planning and Optimization (APO) modules, particularly when dealing with master data or planning data.
  
  Cause:
  The error message usually occurs due to one of the following reasons:
  
  Missing Master Data: The object (e.g., a material, location, or other master data) referenced in the error does not have a corresponding entry in the relevant table.
  Data Inconsistency: There may be inconsistencies in the master data, such as missing or incorrectly configured entries.
  
  Configuration Issues: The system may not be properly configured to recognize the object in question.
  Transport Issues: If the system has recently undergone a transport of changes, some data might not have been transported correctly.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Master Data:
  
  Verify that