How To Fix SATC_ABAP_CHECK200 - Start release must be prior to end release

SAP Error Message - Details

• Message type: E = Error

• Message class: SATC_ABAP_CHECK - ABAP Check Layer

• Message number: 200

• Message text: Start release must be prior to end release

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SATC_ABAP_CHECK200 - Start release must be prior to end release ?

  The SAP error message SATC_ABAP_CHECK200 indicates that there is an issue with the release range specified for a transport request or a similar operation. Specifically, the error message states that the "start release must be prior to end release." This typically occurs when you are trying to perform a check or transport that involves a range of software releases, and the specified start release is not earlier than the end release.
  Cause:
  The error is caused by an incorrect configuration of the release range. This can happen in several scenarios, such as:
  
  When defining a transport request, the start release is set to a version that is later than the end release.
  When performing a system check or upgrade, the release versions specified do not follow the correct chronological order.
  
  Solution:
  To resolve this error, you need to ensure that the start release is indeed earlier than the end release. Here are the steps you can take:
  
  
  Check Release Versions: Verify the release versions you are using. Make sure that the start release is less than the end release.
  
  
  Adjust Transport Request: If you are working with a transport request, go to the transport management system (STMS) and check the details of the transport request. Adjust the release range accordingly.
  
  
  Review Configuration: If this error occurs during a system upgrade or check, review the configuration settings to ensure that the release range is set correctly.
  
  
  Consult Documentation: Refer to SAP documentation or notes related to the specific transaction or operation you are performing. There may be additional guidelines or prerequisites that need to be followed.
  
  
  Contact SAP Support: If you are unable to resolve the issue, consider reaching out to SAP support for assistance. They can provide more specific guidance based on your system configuration and the context of the error.
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as STMS (Transport Management System) and SE01 (Transport Organizer) to manage transport requests effectively.
  SAP Notes: Search for SAP Notes related to transport issues or the specific error message for additional troubleshooting steps or patches.
  System Documentation: Review your system's upgrade or transport documentation to ensure compliance with SAP's best practices.
  
  By following these steps, you should be able to resolve the SATC_ABAP_CHECK200 error and proceed with your intended operation.