How To Fix /SAPAPO/REPDUE016 - Simulation done only for first &1 location products

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/REPDUE -

• Message number: 016

• Message text: Simulation done only for first &1 location products

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/REPDUE016 - Simulation done only for first &1 location products ?

  The SAP error message /SAPAPO/REPDUE016 indicates that a simulation was performed only for the first location's products in the context of SAP Advanced Planning and Optimization (APO). This message typically arises during the execution of a planning run or simulation in the APO system, particularly when dealing with multiple locations.
  Cause:
  
  Configuration Issues: The planning run may not be configured to include all locations or products. This could be due to settings in the planning book or the planning area.
  Data Availability: There may be insufficient data for the other locations or products, leading the system to only process the first location.
  Selection Criteria: The selection criteria used for the simulation might be too restrictive, causing the system to limit the simulation to only the first location.
  System Limitations: There may be performance limitations or restrictions in the system that prevent processing all locations in a single run.
  
  Solution:
  
  Check Configuration: Review the configuration settings in the planning book and planning area to ensure that all relevant locations and products are included in the simulation.
  Review Selection Criteria: Examine the selection criteria used for the simulation. Ensure that it is set up to include all desired locations and products.
  Data Verification: Verify that there is sufficient and correct data for all locations and products. This includes checking master data, transaction data, and any relevant planning parameters.
  Run Simulation for All Locations: If the simulation is intended to cover multiple locations, consider running it separately for each location or adjusting the parameters to include all locations in a single run.
  Consult Documentation: Refer to SAP documentation or notes related to the specific error message for additional insights or updates that may address the issue.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may provide fixes or workarounds for this specific error message.
  APO Documentation: Review the SAP APO documentation for best practices on setting up planning runs and simulations.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after trying the above solutions, it may be beneficial to consult with your SAP support team or a technical consultant who specializes in SAP APO for further assistance.