How To Fix /SAPAPO/PSTRU009 - BUoM &1 of product &2 different than BUoM &3 of planning area &4

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/PSTRU -

• Message number: 009

• Message text: BUoM &1 of product &2 different than BUoM &3 of planning area &4

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/PSTRU009 - BUoM &1 of product &2 different than BUoM &3 of planning area &4 ?

  The SAP error message /SAPAPO/PSTRU009 indicates a mismatch between the Base Unit of Measure (BUoM) of a product and the Base Unit of Measure defined in the planning area. This error typically occurs in the context of Advanced Planning and Optimization (APO) when trying to perform planning activities that require consistency in units of measure.
  Cause:
  
  Mismatch in Units of Measure: The product's BUoM does not match the BUoM defined in the planning area. This can happen if the product was created or modified with a different BUoM than what is expected in the planning area.
  Configuration Issues: There may be configuration issues in the APO system where the product's master data is not aligned with the planning area settings.
  Data Migration Issues: If data was migrated from another system or if there were changes in the product master data, inconsistencies may arise.
  
  Solution:
  
  Check Product Master Data: Verify the Base Unit of Measure for the product in the product master data (transaction code C223 for product master in APO). Ensure that it matches the BUoM defined in the planning area.
  Review Planning Area Settings: Check the planning area configuration (transaction code C4E1 for planning area settings) to confirm the expected BUoM. Make sure it aligns with the product's BUoM.
  Adjust BUoM: If necessary, adjust the BUoM of the product or the planning area to ensure they are consistent. This may involve changing the product's master data or modifying the planning area configuration.
  Re-activate the Product: After making changes, you may need to re-activate the product in the planning area to ensure that the changes take effect.
  Consult Documentation: Refer to SAP documentation or consult with your SAP Basis or APO consultant for specific steps related to your system configuration.
  
  Related Information:
  
  Transaction Codes:
  
  C223: Product Master Data
  C4E1: Planning Area Configuration
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  APO Configuration: Familiarize yourself with the configuration settings in APO, especially those related to product master data and planning area definitions.
  
  By following these steps, you should be able to resolve the error and ensure that the product's BUoM is consistent with the planning area's requirements.