How To Fix /SAPAPO/OM_TS606 - Invalid unit, denominator is 0

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/OM_TS -

• Message number: 606

• Message text: Invalid unit, denominator is 0

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/OM_TS606 - Invalid unit, denominator is 0 ?

  The SAP error message /SAPAPO/OM_TS606 Invalid unit, denominator is 0 typically occurs in the context of Advanced Planning and Optimization (APO) when there is an issue with the unit of measure (UoM) in a planning scenario. This error indicates that there is a division by zero situation, which usually arises from incorrect or missing data related to the units of measure.
  Causes:
  
  Invalid Unit of Measure: The unit of measure being used in the planning process may not be valid or properly defined in the system.
  Zero Denominator: The denominator in a calculation (e.g., a quantity or a rate) is zero, which leads to an invalid calculation.
  Missing Master Data: Required master data (like material master, location master, etc.) may be incomplete or missing, leading to incorrect calculations.
  Configuration Issues: There may be issues with the configuration of the planning area or planning book that lead to incorrect unit conversions or calculations.
  
  Solutions:
  
  Check Unit of Measure: Verify that the unit of measure used in the planning process is valid and correctly defined in the system. Ensure that it is set up in the relevant master data.
  Review Master Data: Ensure that all necessary master data is complete and correctly maintained. Check for any missing or incorrect entries in the material master, location master, or other relevant data.
  Inspect Planning Area Configuration: Review the configuration of the planning area and planning book to ensure that all settings are correct and that there are no issues with the way units are being handled.
  Data Consistency Check: Run consistency checks on the data to identify any discrepancies or issues that may be causing the error.
  Debugging: If the issue persists, consider debugging the process to identify the exact point of failure and the specific data causing the division by zero.
  
  Related Information:
  
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message. SAP frequently updates its knowledge base with solutions for common problems.
  Transaction Codes: Use transaction codes like /SAPAPO/OM17 (for planning book maintenance) or /SAPAPO/OM00 (for planning area maintenance) to review and adjust settings.
  Documentation: Refer to SAP documentation for Advanced Planning and Optimization for detailed information on unit of measure handling and planning area configuration.
  
  If the problem continues after trying the above solutions, it may be beneficial to consult with your SAP support team or reach out to SAP support for further assistance.