How To Fix /SAPAPO/OM_ERROR2348 - Error tolern. has been specified in both scheduler and control parameters

/SAPAPO/OM_ERROR2348 - Overview

• Message type: E = Error

• Message class: /SAPAPO/OM_ERROR2 -

• Message number: 348

• Message text: Error tolern. has been specified in both scheduler and control parameters

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

/SAPAPO/OM_ERROR2348 - Details

• The SAP error message /SAPAPO/OM_ERROR2348 indicates that there is a conflict in the configuration of error tolerances in the Advanced Planning and Optimization (APO) module. Specifically, it states that an error tolerance has been specified in both the scheduler and the control parameters, which leads to ambiguity in how the system should handle error tolerances during planning runs.
  
  Cause:
  This error typically arises when:
  
  Duplicate Configuration: The error tolerance is defined in both the scheduling parameters and the control parameters for a planning run. This can happen if the settings are not aligned or if there are conflicting values.
  Inconsistent Settings: The settings for error tolerances in different areas of the configuration may not match, leading to confusion for the system on which value to prioritize.
  
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Scheduler Parameters:
  
  Go to the transaction code for the relevant planning area (e.g., /SAPAPO/SDP94 for the SNP planning book).
  Review the scheduler