How To Fix /SAPAPO/OM_ERROR330 - Bucket vector header specified for non-bucket resource

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/OM_ERROR -

• Message number: 330

• Message text: Bucket vector header specified for non-bucket resource

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/OM_ERROR330 - Bucket vector header specified for non-bucket resource ?

  The SAP error message /SAPAPO/OM_ERROR330 indicates that there is an issue with the configuration of a non-bucket resource in the SAP Advanced Planning and Optimization (APO) module. Specifically, this error occurs when a bucket vector header is specified for a resource that is not defined as a bucket resource.
  Cause:
  
  Resource Configuration: The resource in question is configured as a non-bucket resource, but the system is trying to use a bucket vector header. This mismatch leads to the error.
  Planning Version: The planning version being used may not be compatible with the resource settings.
  Data Inconsistency: There may be inconsistencies in the master data or planning data related to the resource.
  
  Solution:
  
  
  Check Resource Settings:
  
  Go to the resource master data in the SAP APO system.
  Verify that the resource is correctly defined as a bucket or non-bucket resource based on your planning requirements.
  If the resource should be a bucket resource, change its configuration accordingly.
  
  
  
  Adjust Bucket Vector Header:
  
  If the resource is intended to be a non-bucket resource, ensure that no bucket vector headers are being referenced in your planning runs or data settings.
  
  
  
  Review Planning Version:
  
  Ensure that the planning version you are using is compatible with the resource settings. You may need to adjust the planning version or the resource configuration.
  
  
  
  Data Consistency Check:
  
  Perform a consistency check on the master data and planning data to identify any discrepancies that may be causing the issue.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to this error for any specific guidelines or updates that may apply to your version of SAP APO.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide insights based on the specific configuration and version of your system.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  APO Documentation: Review the official SAP APO documentation for detailed information on resource configuration and planning processes.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.