How To Fix /SAPAPO/OM814 - &1 time series were changed

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/OM -

• Message number: 814

• Message text: &1 time series were changed

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/OM814 - &1 time series were changed ?

  The SAP error message /SAPAPO/OM814 typically indicates that there has been a change in the time series data for a specific key figure in the Advanced Planning and Optimization (APO) module. This error can occur in various scenarios, such as during planning runs, data uploads, or when executing certain transactions.
  Cause:
  The error message /SAPAPO/OM814 is triggered when:
  
  Data Changes: The time series data for a key figure has been modified, which may include changes in the underlying data or configuration.
  Inconsistent Data: There may be inconsistencies in the data that are causing the system to reject the changes.
  Locking Issues: Another user or process may have locked the time series data, preventing your changes from being applied.
  Planning Version Issues: The planning version being used may not be compatible with the changes being made.
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Data Consistency:
  
  Verify that the time series data is consistent and that there are no discrepancies in the key figures involved.
  
  
  
  Review Change Logs:
  
  Check the change logs for the time series data to identify what changes were made and by whom. This can help you understand the context of the error.
  
  
  
  Release Locks:
  
  If the data is locked by another user or process, you may need to wait for the lock to be released or contact the user to release it.
  
  
  
  Reprocess the Data:
  
  If the error occurred during a planning run or data upload, try reprocessing the data after ensuring that all changes are consistent and that there are no locks.
  
  
  
  Check Planning Versions:
  
  Ensure that you are using the correct planning version and that it is set up properly for the changes you are trying to make.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific error message for additional troubleshooting steps or patches that may be available.
  
  
  
  Contact SAP Support:
  
  If the issue persists after trying the above steps, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may want to use transaction codes like /SAPAPO/TS (Time Series) to view and analyze the time series data.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.