How To Fix /SAPAPO/MVM_CONS_CHK019 - PDS &1: Location product &2 ( &3 ) is not assigned to model &4

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/MVM_CONS_CHK -

• Message number: 019

• Message text: PDS &1: Location product &2 ( &3 ) is not assigned to model &4

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/MVM_CONS_CHK019 - PDS &1: Location product &2 ( &3 ) is not assigned to model &4 ?

  The SAP error message /SAPAPO/MVM_CONS_CHK019 indicates that there is an issue with the assignment of a Product Data Structure (PDS) to a model in the SAP Advanced Planning and Optimization (APO) module. Specifically, the error states that a certain location product is not assigned to the specified model.
  Cause:
  This error typically arises due to one of the following reasons:
  
  Missing Assignment: The location product (identified by the product and location combination) is not assigned to the planning model in the APO system.
  Incorrect Configuration: There may be a misconfiguration in the model setup or the PDS configuration.
  Data Inconsistency: There could be inconsistencies in the master data, such as the product or location not being properly defined or activated in the system.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Model Assignment:
  
  Go to the APO system and check the model configuration.
  Ensure that the location product is correctly assigned to the model in question.
  
  
  
  Assign Location Product to Model:
  
  If the location product is not assigned, you can assign it by navigating to the relevant transaction in APO (e.g., /SAPAPO/MVM for model management).
  Add the location product to the model.
  
  
  
  Verify PDS Configuration:
  
  Check the PDS for the product and ensure that it is correctly set up.
  Make sure that the PDS is active and properly configured for the location.
  
  
  
  Check Master Data:
  
  Verify that the product and location master data are correctly defined in the system.
  Ensure that there are no missing or incorrect entries in the master data.
  
  
  
  Re-run Planning:
  
  After making the necessary changes, re-run the planning process to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as /SAPAPO/MVM for model management and /SAPAPO/PDS for PDS management.
  Documentation: Refer to SAP documentation for detailed guidance on model and PDS configuration.
  Support: If the issue persists after following the above steps, consider reaching out to SAP support or consulting with an SAP APO expert for further assistance.
  
  By following these steps, you should be able to resolve the error and ensure that the location product is properly assigned to the model in your SAP APO system.