How To Fix /SAPAPO/FCS_BOM041 - The range of BOM key figure &1 in planning area &2 changed to &3

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/FCS_BOM -

• Message number: 041

• Message text: The range of BOM key figure &1 in planning area &2 changed to &3

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/FCS_BOM041 - The range of BOM key figure &1 in planning area &2 changed to &3 ?

  The SAP error message /SAPAPO/FCS_BOM041 indicates that there has been a change in the range of a Bill of Materials (BOM) key figure in a specific planning area. This message typically arises in the context of SAP Advanced Planning and Optimization (APO) when there are discrepancies or changes in the data that affect the BOM key figures.
  Cause:
  
  Data Changes: The most common cause of this error is that the range of the BOM key figure has been modified. This could happen due to changes in the master data, such as the BOM itself, or changes in the planning area configuration.
  Configuration Issues: If the planning area has been reconfigured or if there are inconsistencies in the data model, it can lead to this error.
  Data Uploads: If there are bulk uploads or data migrations that affect the BOM key figures, this error may occur if the new data does not align with the existing configuration.
  
  Solution:
  
  Check BOM Configuration: Review the BOM configuration in the system to ensure that the key figures are correctly defined and that their ranges are appropriate for the planning area in question.
  Data Consistency: Ensure that the data in the planning area is consistent. You may need to run consistency checks or data validation processes to identify and correct any discrepancies.
  Reprocess Data: If the error occurred after a data upload or change, consider reprocessing the data or rolling back the changes to restore the previous state.
  Adjust Key Figure Ranges: If the key figure ranges have been changed intentionally, ensure that all dependent processes and configurations are updated accordingly.
  Consult Documentation: Refer to SAP documentation or notes related to BOM key figures and planning areas for specific guidance on resolving this error.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like /SAPAPO/MC62 (for key figure settings) or /SAPAPO/MC73 (for planning area settings) to review and adjust configurations.
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide patches related to this error message.
  Support: If the issue persists, consider reaching out to SAP support for assistance, providing them with detailed information about the error and the context in which it occurred.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.