How To Fix /SAPAPO/DEPL_MESS124 - Rounding parameters for location product &1 &2 not found

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/DEPL_MESS -

• Message number: 124

• Message text: Rounding parameters for location product &1 &2 not found

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/DEPL_MESS124 - Rounding parameters for location product &1 &2 not found ?

  The SAP error message /SAPAPO/DEPL_MESS124 indicates that the rounding parameters for a specific location product combination are not found in the system. This error typically occurs in the context of Advanced Planning and Optimization (APO) when dealing with deployment or planning processes.
  Cause:
  
  Missing Rounding Parameters: The primary cause of this error is that the rounding parameters for the specified location product (identified by &1 and &2 in the error message) have not been defined in the system.
  Configuration Issues: There may be a configuration issue where the rounding parameters were not set up correctly or were deleted.
  Data Inconsistency: There could be inconsistencies in the master data or configuration settings that lead to the absence of the required rounding parameters.
  
  Solution:
  
  
  Define Rounding Parameters:
  
  Go to the relevant configuration transaction in SAP APO (usually in the SAP GUI).
  Navigate to the section where rounding parameters are defined (this is typically found under the deployment or planning settings).
  Create or update the rounding parameters for the specific location product combination that is causing the error.
  
  
  
  Check Master Data:
  
  Ensure that the location product master data is correctly maintained.
  Verify that the product and location are active and properly configured in the system.
  
  
  
  Review Configuration Settings:
  
  Check the configuration settings for the APO system to ensure that all necessary parameters are set up correctly.
  If you have recently made changes to the configuration, review those changes to ensure they did not inadvertently remove or alter the rounding parameters.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for guidance on how to set up rounding parameters correctly.
  
  
  
  Testing:
  
  After making the necessary changes, run a test to ensure that the error no longer occurs and that the planning or deployment process can proceed without issues.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like /SAPAPO/DP (for Demand Planning) or /SAPAPO/SDP94 (for Supply Network Planning) to access relevant planning areas and settings.
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message.
  Support: If the issue persists after following the above steps, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  By addressing the missing rounding parameters and ensuring that all related configurations are correct, you should be able to resolve the error message and continue with your planning processes in SAP APO.