How To Fix /SAPAPO/CFM_MSG103 - Key figures &1 and &2 must have the same unit characteristics assigned

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/CFM_MSG -

• Message number: 103

• Message text: Key figures &1 and &2 must have the same unit characteristics assigned

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/CFM_MSG103 - Key figures &1 and &2 must have the same unit characteristics assigned ?

  The SAP error message /SAPAPO/CFM_MSG103 indicates that there is a mismatch in the unit characteristics assigned to two key figures in the SAP Advanced Planning and Optimization (APO) module. This error typically arises when you are trying to perform operations that involve these key figures, such as calculations or comparisons, and they do not share the same unit of measure.
  Cause:
  
  Different Units of Measure: The key figures involved have been defined with different units of measure (e.g., one might be in kilograms while the other is in pounds).
  Configuration Issues: There may be a configuration issue in the key figure settings where the unit characteristics were not properly aligned.
  Data Entry Errors: During data entry or data import, key figures may have been assigned incorrect or inconsistent units.
  
  Solution:
  
  
  Check Key Figure Definitions:
  
  Go to the key figure definitions in the SAP APO system.
  Verify the unit characteristics assigned to both key figures involved in the error.
  Ensure that both key figures have the same unit of measure.
  
  
  
  Adjust Unit Characteristics:
  
  If the units are different, you may need to change the unit of one of the key figures to match the other.
  This can typically be done in the key figure configuration settings.
  
  
  
  Data Consistency Check:
  
  Perform a consistency check on the data to ensure that all entries for the key figures are using the correct and consistent units.
  Correct any discrepancies found during this check.
  
  
  
  Reconfigure Key Figures:
  
  If necessary, you may need to reconfigure the key figures to ensure they are set up correctly for your planning scenario.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help resources for specific guidance on key figure configuration and unit characteristics.
  
  
  
  Related Information:
  
  Key Figures in SAP APO: Key figures are essential components in SAP APO that represent quantitative data used in planning processes. Each key figure can have specific characteristics, including units of measure.
  Unit of Measure (UoM): In SAP, units of measure are critical for ensuring that data is consistent and can be accurately compared or calculated.
  SAP Notes and Support: If the issue persists, consider checking SAP Notes for any known issues or patches related to this error message. You can also reach out to SAP support for assistance.
  
  By following these steps, you should be able to resolve the error and ensure that the key figures are correctly configured for your planning needs.