How To Fix /SAPAPO/ATP208 - The target unit &1 is unknown

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/ATP -

• Message number: 208

• Message text: The target unit &1 is unknown

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/ATP208 - The target unit &1 is unknown ?

  The SAP error message /SAPAPO/ATP208 indicates that the target unit specified in the system is unknown. This error typically occurs in the context of Advanced Planning and Optimization (APO) when dealing with Available-to-Promise (ATP) checks or similar functionalities.
  Cause:
  
  Incorrect Unit of Measure (UoM): The target unit specified in the transaction or configuration does not exist in the system or is not defined correctly.
  Missing Master Data: The material master data may not have the required unit of measure defined.
  Configuration Issues: There may be issues in the configuration settings related to the product or the planning area.
  Data Inconsistency: There could be inconsistencies in the data, such as missing entries in the relevant tables.
  
  Solution:
  
  
  Check Unit of Measure:
  
  Verify that the target unit of measure is correctly defined in the system. You can do this by checking the material master data (transaction MM03) and ensuring that the unit of measure is listed under the relevant views.
  
  
  
  Maintain Master Data:
  
  If the target unit is missing, you may need to add it to the material master. This can be done using transaction MM02 to modify the material and add the necessary unit of measure.
  
  
  
  Review Configuration:
  
  Check the configuration settings in the APO system. Ensure that the planning area and other relevant settings are correctly configured to recognize the target unit of measure.
  
  
  
  Check for Data Consistency:
  
  Run consistency checks in the APO system to identify any discrepancies in the master data or configuration. You can use transaction /SAPAPO/TS to check for inconsistencies.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or notes related to this error message for any specific recommendations or patches that may address the issue.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. Provide them with the error message details and any relevant context to help diagnose the problem.
  
  
  
  Related Information:
  
  
  Transaction Codes: 
  
  MM03 (Display Material)
  MM02 (Change Material)
  /SAPAPO/TS (Consistency Check)
  
  
  
  SAP Notes: Search for relevant SAP Notes in the SAP Support Portal that may address this specific error or provide additional troubleshooting steps.
  
  
  Documentation: Review the SAP Help Portal for information on ATP checks and unit of measure handling in APO.
  
  
  By following these steps, you should be able to identify and resolve the issue related to the /SAPAPO/ATP208 error message.