How To Fix S_UCON_LM218 - Invalid name for communication assembly.

SAP Error Message - Details

• Message type: E = Error

• Message class: S_UCON_LM - Messages for Unified Connectivity LM process

• Message number: 218

• Message text: Invalid name for communication assembly.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message S_UCON_LM218 - Invalid name for communication assembly. ?

  The SAP error message S_UCON_LM218, which states "Invalid name for communication assembly," typically occurs in the context of SAP's Unified Connectivity (UCON) framework. This error indicates that there is an issue with the naming convention or configuration of a communication assembly that is being used in your SAP system.
  Causes:
  
  Invalid Naming Convention: The name of the communication assembly does not conform to the expected naming conventions or contains invalid characters.
  Configuration Issues: The communication assembly may not be properly configured in the system, leading to recognition issues.
  Missing Components: The required components or dependencies for the communication assembly may not be installed or activated.
  Transport Issues: If the communication assembly was transported from another system, there may have been issues during the transport process.
  
  Solutions:
  
  Check Naming Conventions: Ensure that the name of the communication assembly adheres to the required naming conventions. Typically, names should be alphanumeric and may not contain special characters or spaces.
  Review Configuration: Go through the configuration settings for the communication assembly in the SAP system. Ensure that all parameters are correctly set and that the assembly is properly defined.
  Verify Installation: Make sure that all necessary components for the communication assembly are installed and activated in your SAP system.
  Check Transport Logs: If the assembly was transported, review the transport logs for any errors or warnings that may indicate what went wrong during the transport process.
  Consult Documentation: Refer to SAP documentation or notes related to Unified Connectivity and communication assemblies for any specific guidelines or troubleshooting steps.
  Contact SAP Support: If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  SAP Community: Engage with the SAP Community forums where other users may have encountered similar issues and can share their solutions.
  Documentation: Review the official SAP documentation on Unified Connectivity for detailed information on configuration and best practices.
  
  By following these steps, you should be able to identify and resolve the issue related to the S_UCON_LM218 error message in your SAP system.