How To Fix S1025 - Use time >= & sec or stat/recno <= & for good monitor

S1025 - Overview

• Message type: E = Error

• Message class: S1 - Statistik / SAP-Monitor

• Message number: 025

• Message text: Use time >= & sec or stat/recno <= & for good monitor

What causes this issue?

The selected time interval for the statictics alert monitor was too
short to obtain representative data. Since statistics data are held in
a local buffer before being written to a sequential statistics file
(from where they can be read), they are written to the file in
"clusters". The average measured time which elapses until a "cluster"
is written to the file should be used as the minimum time for
refreshing the alert monitor.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Select a larger value in the "time interval" option.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message S1025 - Use time >= & sec or stat/recno <= & for good monitor ?

  The SAP error message S1025 typically indicates an issue related to the monitoring of a process or transaction in the SAP system. This error message suggests that the time used for monitoring is not sufficient or that the status/record number is not within the expected range for effective monitoring.
  
  Cause:
  
  Insufficient Time Interval: The time interval specified for monitoring is less than the required threshold. This can happen if the monitoring settings are not configured correctly or if the system is under heavy load.
  Incorrect Status/Record Number: The status or record number being referenced is outside the acceptable range, which can occur due to data inconsistencies or incorrect parameters being passed to the monitoring function.
  
  
  Solution:
  
  
  Adjust Time Settings: 
  
  Review the monitoring configuration settings in the SAP system. Ensure that the time interval for monitoring is set to a value greater than or equal to the specified threshold (e.g., & sec).
  If you are using a