How To Fix RSUOM098 - &1 &2 -> &3 &4

SAP Error Message - Details

• Message type: E = Error

• Message class: RSUOM - BW: Conversion of Units of Measure

• Message number: 098

• Message text: &1 &2 -> &3 &4

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message RSUOM098 - &1 &2 -> &3 &4 ?

  The SAP error message RSUOM098 typically relates to issues with unit of measure (UoM) conversions or definitions in the SAP system. The message format you provided indicates that there are specific parameters that are being referenced, which can help in diagnosing the issue.
  Cause:
  
  Incorrect Unit of Measure: The error may occur if the unit of measure being used is not defined in the system or is not compatible with the operation being performed.
  Missing Conversion Factors: If there are no conversion factors defined between the units of measure involved, the system will not be able to perform the necessary calculations.
  Data Inconsistencies: There may be inconsistencies in the master data related to materials, such as incorrect UoM settings in the material master record.
  Configuration Issues: The configuration settings for units of measure in the SAP system may not be set up correctly.
  
  Solution:
  
  Check Unit of Measure Definitions: Go to the transaction code CUNI (Unit of Measure Conversion) and verify that the units of measure involved in the error are defined correctly.
  Review Material Master Data: Use transaction code MM03 to check the material master data for the relevant materials. Ensure that the UoM settings are correct and that the base unit of measure is properly defined.
  Define Conversion Factors: If conversion factors are missing, you can define them in the same transaction (CUNI) or through the material master data.
  Check Configuration: Review the configuration settings for units of measure in the SAP system. This can be done through the SPRO transaction (SAP Reference IMG) under Logistics > General > Material Master > Settings for Key Fields > Define Units of Measure.
  Consult Documentation: If the issue persists, consult SAP documentation or support for further guidance on the specific error message and its parameters.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as MM03, CUNI, and SPRO.
  SAP Notes: Check for any SAP Notes related to RSUOM098 for additional insights or patches that may address the issue.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed.
  
  If you continue to experience issues after following these steps, it may be beneficial to reach out to your SAP support team for further assistance.