How To Fix RSUOM065 - No quantity conversion possible

SAP Error Message - Details

• Message type: E = Error

• Message class: RSUOM - BW: Conversion of Units of Measure

• Message number: 065

• Message text: No quantity conversion possible

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message RSUOM065 - No quantity conversion possible ?

  The SAP error message RSUOM065: No quantity conversion possible typically occurs when there is an attempt to convert a quantity from one unit of measure (UoM) to another, but the system cannot find a valid conversion factor between the two units. This can happen in various scenarios, such as during the processing of goods movements, inventory management, or when creating purchase orders.
  Causes:
  
  Missing Conversion Factors: The most common cause is that the conversion factors between the source and target units of measure are not defined in the system.
  Incorrect Unit of Measure: The units of measure being used may not be compatible or may not exist in the system.
  Configuration Issues: There may be issues with the configuration of the units of measure in the material master or in the relevant customizing settings.
  Data Inconsistencies: There could be inconsistencies in the data, such as missing or incorrect entries in the unit of measure tables.
  
  Solutions:
  
  
  Check Unit of Measure Settings:
  
  Go to the material master (transaction code MM03) and check the units of measure defined for the material. Ensure that the base unit of measure and any alternative units of measure are correctly set up.
  Verify that the conversion factors between the units of measure are defined in the material master.
  
  
  
  Define Conversion Factors:
  
  If conversion factors are missing, you can define them in the material master under the "Units of Measure" view. Make sure to specify the correct conversion ratio.
  
  
  
  Review Configuration:
  
  Check the configuration settings for units of measure in the SAP customizing (transaction code SPRO). Navigate to Logistics - General > Material Master > Basic Settings > Units of Measure and ensure that the necessary settings are in place.
  
  
  
  Check for Data Inconsistencies:
  
  Run reports or use transaction codes like SE16 or SE11 to check the relevant tables (e.g., T006 for units of measure) for any inconsistencies or missing entries.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help resources for additional guidance on unit of measure conversions and related settings.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: MM03 (Display Material), MM02 (Change Material), SPRO (Customizing).
  Tables: T006 (Units of Measure), T006A (Unit of Measure Descriptions).
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to unit of measure conversions.
  
  By following these steps, you should be able to identify and resolve the cause of the RSUOM065 error in SAP.