How To Fix RSUOM048 - Source unit of measure: Enter attribute

SAP Error Message - Details

• Message type: E = Error

• Message class: RSUOM - BW: Conversion of Units of Measure

• Message number: 048

• Message text: Source unit of measure: Enter attribute

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message RSUOM048 - Source unit of measure: Enter attribute ?

  The SAP error message RSUOM048 typically occurs in the context of unit of measure (UoM) conversions or when dealing with material master data. This error indicates that the system requires an attribute for the source unit of measure, which has not been provided.
  Cause:
  The error is usually caused by one of the following reasons:
  
  Missing Attribute: The source unit of measure does not have a required attribute defined in the system.
  Configuration Issues: There may be issues in the configuration of the unit of measure settings in the material master or in the relevant customizing settings.
  Data Inconsistency: There might be inconsistencies in the data related to the material or the units of measure being used.
  
  Solution:
  To resolve the RSUOM048 error, you can follow these steps:
  
  
  Check Material Master Data:
  
  Go to the material master record (transaction code MM03) and check the unit of measure settings.
  Ensure that the source unit of measure is correctly defined and that all required attributes are filled in.
  
  
  
  Review Unit of Measure Configuration:
  
  Access the configuration settings for units of measure (transaction code SPRO).
  Navigate to the relevant section for defining units of measure and check if the source unit of measure has the necessary attributes assigned.
  
  
  
  Define Attributes:
  
  If the source unit of measure is missing attributes, you may need to define them. This can typically be done in the customizing settings for units of measure.
  
  
  
  Check for Data Inconsistencies:
  
  Run consistency checks on the material master data to identify any discrepancies that may be causing the error.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific details on the attributes required for the source unit of measure.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: MM03 (Display Material), MM02 (Change Material), SPRO (Customizing).
  Unit of Measure Settings: Ensure that the units of measure are correctly defined in the system and that they comply with the business requirements.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  
  By following these steps, you should be able to identify and resolve the cause of the RSUOM048 error in your SAP system.