How To Fix RSTCO_ACT312 - Task &1 started in check mode

SAP Error Message - Details

• Message type: E = Error

• Message class: RSTCO_ACT - Activation of technical content

• Message number: 312

• Message text: Task &1 started in check mode

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message RSTCO_ACT312 - Task &1 started in check mode ?

  The SAP error message RSTCO_ACT312 indicates that a task (denoted by &1) has been started in check mode. This typically occurs during the execution of a task that is intended to perform data consistency checks or validations rather than making actual changes to the database or system.
  Cause:
  The primary cause of this error message is that the task was initiated in a mode that is designed for checking or validation purposes. This can happen if:
  
  The task was explicitly started in check mode by the user.
  There is a configuration or parameter setting that defaults the task to check mode.
  The system is set up to run certain tasks in check mode to prevent unintended changes during testing or validation phases.
  
  Solution:
  To resolve this issue, you can take the following steps:
  
  
  Check Task Parameters: Review the parameters or settings used to start the task. Ensure that it is not set to run in check mode if you intend to perform actual changes.
  
  
  Run in Update Mode: If you want to execute the task for real (i.e., to make changes), you need to start it in update mode. This can usually be done by:
  
  Modifying the command or transaction used to start the task.
  Using the appropriate flags or options that indicate you want to run the task in update mode.
  
  
  
  Consult Documentation: Refer to the SAP documentation or help files related to the specific task you are trying to execute. This can provide insights into how to properly configure and run the task.
  
  
  Check User Permissions: Ensure that your user account has the necessary permissions to execute the task in update mode. Sometimes, restrictions may prevent certain users from making changes.
  
  
  Testing Environment: If you are in a testing environment, it may be intentional to run tasks in check mode to avoid data corruption. Confirm with your team if this is the case.
  
  
  Related Information:
  
  Transaction Codes: Depending on the task, you may be using specific transaction codes (e.g., SE38 for executing reports, or others specific to your SAP module).
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional context.
  Logs and Traces: Review system logs or traces to gather more information about why the task was initiated in check mode.
  
  If you continue to experience issues or if the task is critical, consider reaching out to your SAP Basis or technical support team for further assistance.